Thingiverse
Tronxy 802 Hotend Cable Holder
by K-rnix
18
Downloads
5
Likes
0
Makes
I did this for my Tronxy P802 Prusa Clone. The hotend cable was grinding over the frame, so I decided to have a holder for it.
The actual holder is about 45 degrees because the cable comes from the left, so there was no point to be 90 degrees.
My Tronxy has frames 8mm thick, and also the "sandwich" of the LCD board.
The actual holder is about 45 degrees because the cable comes from the left, so there was no point to be 90 degrees.
My Tronxy has frames 8mm thick, and also the "sandwich" of the LCD board.
Sign in to leave a comment
Sign in