Anet A8 Mosfet Case - Remix for T Corner Brace

I was about to print the original when I noticed it didn't have allowance for the T Corner frame brace.

This is my first remix, so go easy on a n00b! I used tinkercad.com for the remix. I enlarged the T-Corner brace by 1% then subtracted it from the model.

EDIT 7/13/17: You might have to slightly trim the top where the T corner goes, where the little angled piece of the wall is, next to the top right standoff.

EDIT 7/18/17: V2 has the above mentioned piece removed, and the bottom hole i