Thingiverse

Z level checker

by wenzej

85 Downloads

62 Likes

2 Makes

Download Model

anet a6 Anet A8 bed leveling calibration test tools anet a6 Anet A8 bed leveling calibration test tools anet a6 Anet A8 bed leveling calibration test tools anet a6 Anet A8 bed leveling calibration test tools anet a6 Anet A8 bed leveling calibration test tools

This is a gadget I built to check if both sides of Z are at the same height. You just slide it under one side, with the base on a level surface that the printer is on. slide the Feeler up the shaft until it touches the base of Z near the screws. You might want to press down on the end to make sure it is not going to move it might be slanted down a little. tighten the screw and move it to the other side and see if it is at the same height. with the motors powered down you can adjust this b

Source

Thingiverse

Comments