Hypercube Evolution (NO brass inserts Version)8mm X-carriage

Making some changes to the X carriage so that 3mm nuts can be used instead of brass inserts. I found the inserts were a little close to the side wall and messed up my bearing alignment.

If the bearing were in stalled before the inserts then there will be no problem but i decided to make the change anyway.

if you like this you might also like the YX carriages no brass inserts version also: https://www.thingiverse.com/thing:2469902


7.15.2017 Revision 1 & 2. These semi tested
Rev1