Thingiverse

LED strip mount for Robo R2 printer

by Kilrah

45 Downloads

30 Likes

1 Makes

Download Model

Led Holder led mount led strip robo3d RoBo 3D Led Holder led mount led strip robo3d RoBo 3D Led Holder led mount led strip robo3d RoBo 3D Led Holder led mount led strip robo3d RoBo 3D Led Holder led mount led strip robo3d RoBo 3D

Was getting tired of not seeing anything in my R2 (stock lighting if we can call it that is utterly useless), so I installed 2x 12-LED long pieces of strip on top.
This mount follows the curve of the printer and gives a 40° downwards angle to the LEDs. The strip can be stuck right on, and use double sided foam tape to stick to the printer.

Both pieces of 12V strip are wired in series and connected to the 24V power input behind the power switch (first 2 pins of the green connector, see photo)

Source

Thingiverse

Comments