Thingiverse
Wire Shelf Support (30 Degrees)
by denos
6
Downloads
6
Likes
0
Makes
Our house had a bunch of 30 degree wire shelves but the original support design was weak and several have broken over time.
This is my attempt at creating something stronger. It's basically an I-Beam that has been rounded to print without supports. The I-Beam also supports both faces to prevent them from fracturing along the center line (the most common failure point).
This is my attempt at creating something stronger. It's basically an I-Beam that has been rounded to print without supports. The I-Beam also supports both faces to prevent them from fracturing along the center line (the most common failure point).
Sign in to leave a comment
Sign in