Thingiverse

Retro Turn Signal Lens

by Shootquinn

10 Downloads

12 Likes

0 Makes

Download Model

Made to replace a 2.2" long 1.4" / 1.6" O.D. 1.2" I.D. retro blinker lens from my dad's custom Saab two-stroke powered trike. Square hole is to drill to #40 and then tap / go up from there. Nub is present on old lens, not sure if it indexes on the housing or not.

Added nut trap for 1/4" nut 7/22/17.

Print Instructions: 1 shell, 20% infill, 6 top layers 4 bottom layers, .6mm extrusion width, .2mm layer height (.25 for first layer). Slow, like 25mm/sec.

Filament in picture is gizmo dork

Source

Thingiverse

Comments