Thingiverse

E3D v6 X Carriage Minimal

by wafflejock

7 Downloads

1 Likes

0 Makes

Download Model

Printed in Taulman 645 Nylon at 10% infill seems rigid enough to do the job. Just wanted something that fit my RepRap Guru Prusa i3 based kit, span between the rails was 45mm, span between the belt coming in and going out was 15mm. Would have been good to make the gap where the belts wrap around the back slightly wider to make it easier to get the belts into there but just trimmed off some of the plastic with an exacto knife on my actual print and that worked fine.

Uses 2 M4 screws and nuts

Source

Thingiverse

Comments