Thingiverse
Wanhao Duplicator 6 Air Inducement Duct
by Reflector
29
Downloads
19
Likes
0
Makes
Edit: Offset fan version for anyone interested
https://www.thingiverse.com/thing:2448580
I tried printing an air inducement shroud for the Duplicator 6 but it was:
Far, far too thin all over
Square in the channel profile (How is this good for airflow?)
Relatively fragile during removal
Slic3r hated it (It also hates what I made so this is OK)
Something about printing another one of them and then trying to remove it from the bed unsuccessfully, again.
With that, I wanted t
https://www.thingiverse.com/thing:2448580
I tried printing an air inducement shroud for the Duplicator 6 but it was:
Far, far too thin all over
Square in the channel profile (How is this good for airflow?)
Relatively fragile during removal
Slic3r hated it (It also hates what I made so this is OK)
Something about printing another one of them and then trying to remove it from the bed unsuccessfully, again.
With that, I wanted t
Sign in to leave a comment
Sign in