Thingiverse

EZABL Compatible CR-10 MicroSwiss Full Metal Hotend Fang

by jantzenday

74 Downloads

39 Likes

0 Makes

Download Model

18mm auto CR-10 Creality EZABL fang hotend level metal MicroSwiss sensor 18mm auto CR-10 Creality EZABL fang hotend level metal MicroSwiss sensor 18mm auto CR-10 Creality EZABL fang hotend level metal MicroSwiss sensor 18mm auto CR-10 Creality EZABL fang hotend level metal MicroSwiss sensor 18mm auto CR-10 Creality EZABL fang hotend level metal MicroSwiss sensor

*THIS HAS NOT BEEN PRINTED OR TESTED YET SO I HAVE NOT MEASURED THE SENSOR OFFSETS. YOU MUST MEASURE YOUR OFFSETS AND ENTER THEM INTO YOUR FIRMWARE*

This is a fang for the CR-10 with a MicroSwiss full metal hotend installed that is compatible with Timothy Hoogland's EZABL 18mm auto bed leveling kit. The sensor mount was added using Meshmixer. I have not printed yet as i do not currently have my MS hotend installed but it should print and function fine. I will update with pictures and any fix

Source

Thingiverse

Comments