Thingiverse
Extruder wire brace for Kodama Trinus
by Singular
2
Downloads
4
Likes
0
Makes
Can be used for anything really but it was designed to fit snuggly over the extruder head cables for the Kodama Trinus after wrapping it in electrical tape.
The inner diameter of the round section is 9.3 mm. The base comes together and leaves you approximately 2 mm to put your wires through. I added a filet to most edges to help reduce stress on the wires.
I used 3m double sided weather proof sticky tape (the grey stuff). This stuff is amazing and although it says it is permanent I have re
The inner diameter of the round section is 9.3 mm. The base comes together and leaves you approximately 2 mm to put your wires through. I added a filet to most edges to help reduce stress on the wires.
I used 3m double sided weather proof sticky tape (the grey stuff). This stuff is amazing and although it says it is permanent I have re
Sign in to leave a comment
Sign in