Thingiverse
Ultimaker e3D Mount by Jameswood
by m4rten86
23
Downloads
29
Likes
0
Makes
I modified this design from jameswood ( Ultimaker e3D Mount ) to optimize the airflow near the nozzle. i used blender and adjusted the blowholes of both fans to point straight to the nozzle.
Also i extended the hole straight through the Latch and it goes further through the other side of the main Mount so the latch holds on both sides.
All tribute goes to jameswood ( https://www.thingiverse.com/thing:1975308 ) :)
Also i extended the hole straight through the Latch and it goes further through the other side of the main Mount so the latch holds on both sides.
All tribute goes to jameswood ( https://www.thingiverse.com/thing:1975308 ) :)
Sign in to leave a comment
Sign in