Thingiverse
1x4 Female Hose Connector
by bjzq888
9
Downloads
9
Likes
0
Makes
This is a version of my 1x4 hose connector, with a female rather than male hose connector on the end. The male version is here:
https://www.thingiverse.com/thing:1498649
This one has a pretty shallow angle on the "cone" part on the inside...that can cause a bit of stringing. Just cut those off. You might need to shrink the model 1 to 5 percent to get it to fit perfectly in your application. You need a rubber gasket on the inside to get it to seal well.
There are two .stl files. The f
https://www.thingiverse.com/thing:1498649
This one has a pretty shallow angle on the "cone" part on the inside...that can cause a bit of stringing. Just cut those off. You might need to shrink the model 1 to 5 percent to get it to fit perfectly in your application. You need a rubber gasket on the inside to get it to seal well.
There are two .stl files. The f
Sign in to leave a comment
Sign in