Thingiverse
Watersaver / flow restrictor - BSP 3/4" - Standard size
by b03tz
189
Downloads
135
Likes
2
Makes
Print this thing out, slap it on your watertap and save some money on water and help the environment ;)
Drawn from scratch, the 2nd iteration but worked perfectly already. I use a little rubber ring inside it but I think with a bit of teflon tape (or anything of the sorts) it should work just fine without.
I printed this at 45% infill in PETG, works wonders. Print it with the threads down and ONLY support the middle section (you can remove that easily afterwards). The internals print fine
Drawn from scratch, the 2nd iteration but worked perfectly already. I use a little rubber ring inside it but I think with a bit of teflon tape (or anything of the sorts) it should work just fine without.
I printed this at 45% infill in PETG, works wonders. Print it with the threads down and ONLY support the middle section (you can remove that easily afterwards). The internals print fine
Sign in to leave a comment
Sign in