Thingiverse
us navy Engineman "challenge coin"
by pwalter824
34
Downloads
31
Likes
0
Makes
I wanted a Navy emblem to put on my motorcycle and I looked for challenge coins but then I thought I might be unhappy if it falls off so with a 3d printed part, I can just print another one.
Have not tried it yet but I hope to print one this weekend.
I based this on a regular challenge coin but I plan on sizing it up a bit to make it fit.
side note, the reason for this is my bike had two round emblems on the trunk when I bought it but they were masons symbols and when they finally fell of
Have not tried it yet but I hope to print one this weekend.
I based this on a regular challenge coin but I plan on sizing it up a bit to make it fit.
side note, the reason for this is my bike had two round emblems on the trunk when I bought it but they were masons symbols and when they finally fell of
Sign in to leave a comment
Sign in