Thingiverse
bike spoke protector 56,7°, 25cm radius
by rawe
24
Downloads
25
Likes
0
Makes
a simple spoke protector to mount on the bike frame by zip ties. print with some flexible material like ABS. Just fits on the print bed of an prusa 3i mk2.
I use it to keep bags that hang down on the side of the rear wheel away from the spokes.
In constant use since ~1 Month / ~500km. Tested up to 50km/h ;)
Broke after ~1000km of use. Better print it z-scaled 2x (so it is stronger). Since this re-print used for ~1500km without problem.
I use it to keep bags that hang down on the side of the rear wheel away from the spokes.
In constant use since ~1 Month / ~500km. Tested up to 50km/h ;)
Broke after ~1000km of use. Better print it z-scaled 2x (so it is stronger). Since this re-print used for ~1500km without problem.
Sign in to leave a comment
Sign in