Thingiverse
Simple 2020 spool holder
by Wibbly
5
Downloads
2
Likes
0
Makes
I have seen a hundred and one spool holders for 2020 extrusions, but they all look way too complicated for what they do, and lack elegance.
I set about solving the problem using the minimum of filament, the shortest print time, and the easiest fitment.
Here it is. Easiest way to print to avoid needing infill is to use Cura, 50% infill (which is as good as 100%), 0.20. I didn't use any brim or support material.
Print in two halves.
1. Flip the model 180.
Sink the model into the plater
I set about solving the problem using the minimum of filament, the shortest print time, and the easiest fitment.
Here it is. Easiest way to print to avoid needing infill is to use Cura, 50% infill (which is as good as 100%), 0.20. I didn't use any brim or support material.
Print in two halves.
1. Flip the model 180.
Sink the model into the plater
Sign in to leave a comment
Sign in