Thingiverse
Qidi Tech X-One Filament Guide Tube Offset
66
Downloads
32
Likes
4
Makes
Here is my version of a thing that will offset the filament guide tube on the back of the X-One.
The idea is that this will put the guide tube at roughly the center of the spool so that filament doesn't get pulled at funny angles.
Print it standing up. I did not use any supports. I was surprised how well the bridging worked.
If you want to use supports, they should not be that hard to clean out.
Make sure the small hole is on the build plate.
The idea is that this will put the guide tube at roughly the center of the spool so that filament doesn't get pulled at funny angles.
Print it standing up. I did not use any supports. I was surprised how well the bridging worked.
If you want to use supports, they should not be that hard to clean out.
Make sure the small hole is on the build plate.
Sign in to leave a comment
Sign in