Thingiverse
Easy Grasp Refrigerator Magnet
by Doer
6
Downloads
6
Likes
0
Makes
A friend gave me some 6 x 9.7 mm magnets, I made an easy to grip housing for the magnets for a family member. The hole for the magnet is slightly small, so I used the drill press and an "A" size (0.235") bit to make the hole right. Then use a vise to push the magnet in. Works very well. Here is a tip, make sure the magnet does not go in too far, ideally it should stick out very, very slightly, If it is pushed in even a little bit too far, it loses much of its holding power.
Sign in to leave a comment
Sign in