Thingiverse
Layer Fan Duct for MakerParts 3D printer
by ejtagle
19
Downloads
24
Likes
0
Makes
Fan Duct for the MakerParts 3D printer. This one uses a 50mm Radial Fan. The fan itself has 56.7mm between mounting holes, and the output is a rectangle whose exterior dimensions are 19.3mm x 15mm
This thing works wonderfully, and attaches to the heatsink of the E3D v6. You NEED to place kapton tape around the aluminium block of the extruder, otherwise, the fan will cool it down so much the printer will stop extruding!
With this fan duct installed, i was able to print at 200mm/s with no q
This thing works wonderfully, and attaches to the heatsink of the E3D v6. You NEED to place kapton tape around the aluminium block of the extruder, otherwise, the fan will cool it down so much the printer will stop extruding!
With this fan duct installed, i was able to print at 200mm/s with no q
Sign in to leave a comment
Sign in