JG Aurora A3 x belt tensioner
by Beeh1
22
Downloads
15
Likes
0
Makes
X axis belt tensioner for the JG Aurora A3. Attaches to the right side of the printer, as shown in the picture. It fits like a gem, and works just as well. It can get your x axis belt tight, probably too tight. You actually need to put the parts on a certain way, with the thicker side to the right when mounting it, otherwise you should notice it doesn't fit quite right.
You need your own screws and nuts for this, but it should be good with 2*20mm M3 screws. The worst part about this if you're
You need your own screws and nuts for this, but it should be good with 2*20mm M3 screws. The worst part about this if you're
Sign in to leave a comment
Sign in