Thingiverse

Printed solid filler piece (TAZ 6)

by D125

18 Downloads

11 Likes

0 Makes

Download Model

enclosure Filler Lulzbot Taz 6 printedsolid taz enclosure Filler Lulzbot Taz 6 printedsolid taz enclosure Filler Lulzbot Taz 6 printedsolid taz enclosure Filler Lulzbot Taz 6 printedsolid taz enclosure Filler Lulzbot Taz 6 printedsolid taz

This is just one of the filler pieces to cover some of the holes on a printed solid enclosure. Double side tape not required but recommended. one is for thicker tape (2mm) and the other is for thinner or no tape.
Assembly steps
1. Print 2
2. Tap the smaller non-chamfered holes with an 8-32 tap.(or just force the screw.)
3. Assemble pieces as shown
Note- May require sanding of the slot especially at the joint.

Source

Thingiverse

Comments