CR-10 E3D V6 / Lite Hotend mount stabilized

Bandanam4n made a great job with the E3D Hotend mount, but i recognized sagging like ThermoDynamicEntropy too. So i printed ThermoDynamicEntropy´s Remix but unfortunately the position of the Hotend was too far away from the stock position.

So i have taken the same position like Bandanam4n and just added a small mounting place for the left screw.

No more sagging here, nearly Stock position no problems to run the E3D Hotend with stock Firmware. Only a few mm off.

i take my stock thermi