Thingiverse
Notebook Webcam Cover
by gmlupatelli
56
Downloads
46
Likes
0
Makes
This is a small notebook`s webcam privacy cover.
Print it with 0.10mm resolution, since I design it with that in mind, so if you use 0.2mm resolution it may not work.
After printing it you may need to trim the sliding cover sides a bit for a better fit.
To attach it to your notebook use a double sided tape, as shown in the photos. I also use a small piece of tape to hold the sliding cover in place while I install it.
The model is fully customizable and is available at OnShape: http
Print it with 0.10mm resolution, since I design it with that in mind, so if you use 0.2mm resolution it may not work.
After printing it you may need to trim the sliding cover sides a bit for a better fit.
To attach it to your notebook use a double sided tape, as shown in the photos. I also use a small piece of tape to hold the sliding cover in place while I install it.
The model is fully customizable and is available at OnShape: http
Sign in to leave a comment
Sign in