Replicator 2/2X DuetWifi Configuration

Updated 04-06-2020: Config files updated for the latest Version 3.1.1 Firmware release.
(note that the 2nd extruder is disabled in the attached config. Uncomment relevant lines to enable it again)
Added config files for factory default Z Homing switch - NOTE: if used, Duet will ignore any probe inputs and home against the Z-Endstop switch that comes with the Rep2x by default (make sure it is wired up to the Z-Endstop pins on Duet like the X/Y endstop switches are)

This is part 3 of the Repl