Thingiverse
Split Loom Clips for OpenBuilds V-slot Extrusions
by dotorg
74
Downloads
43
Likes
0
Makes
This/These are wire-loom clips that fit into OpenBuilds V-slot extrusions, used in quite a few 3D printers. They allow you to clip the wire bundles to the printer frame.
There's a few on here, but the ones I'd found for 1/2" split-loom were too small, seeming to target 1/2" outer diameter, rather than 1/2" inner diameter.
The initial one uploaded is 17mm inner diameter, which fits the common half-inch plastic split-loom wire wrap. Its 1.5mm thick, sized specifically to print tightly with
There's a few on here, but the ones I'd found for 1/2" split-loom were too small, seeming to target 1/2" outer diameter, rather than 1/2" inner diameter.
The initial one uploaded is 17mm inner diameter, which fits the common half-inch plastic split-loom wire wrap. Its 1.5mm thick, sized specifically to print tightly with
Sign in to leave a comment
Sign in