Wanhao D7 no screws/joint vat

This is my not screw vat simplified for the Wanhao D7 printed in PLA, not possibility bottom lost resin due to the gasket or the screw holes, does not use join plate, the system to adjust the fep is the same as used in the LC10 Photocentric and others (as you can see in the video) that allows to adjust a fep in just a few seconds without need for joints or screws, only double-sided tape, tested and work perfectly in my Wanhao D7 v1.4.

The video describes how to replace the vat film in a photo