Thingiverse
Rear BLTouch Holder. Slim design.
by Tamadite
9
Downloads
7
Likes
0
Makes
NOTE: I have depreciated this model in favour of https://www.thingiverse.com/thing:2667913.
One of the drawbacks of the original design is that it hits the frame of the printer and so it is necessary to extend the X end-stop to avoid printhead collisions with the frame; a consequence of this is a reduced print area, around 0.5cm.
I reworked the design to avoid this problem as well as to make it thiner and lighter: from 13.47g to 9.52g (around 30% lighter).
In order to meet the assembling
One of the drawbacks of the original design is that it hits the frame of the printer and so it is necessary to extend the X end-stop to avoid printhead collisions with the frame; a consequence of this is a reduced print area, around 0.5cm.
I reworked the design to avoid this problem as well as to make it thiner and lighter: from 13.47g to 9.52g (around 30% lighter).
In order to meet the assembling
Sign in to leave a comment
Sign in