Thingiverse
Wanhao D6/Monoprice Ultimate - 50x15mm blower duct - revision 3
by dg3636
36
Downloads
19
Likes
2
Makes
This is an improved cooling solution for a Wanhao Duplicator 6 (D6) / Monoprice Ultimate. This blower duct is small and simple: it channels the airflow to a smaller cross-section to increase the air speed, and directs the focused airflow at the extrusion point while avoiding cooling of the whole metal block (and thus avoiding bad heating errors).
You will want to slowly ramp up the fan speed, or else you will overcool and force the firmware to terminate the print (respond as though the hea
You will want to slowly ramp up the fan speed, or else you will overcool and force the firmware to terminate the print (respond as though the hea
Sign in to leave a comment
Sign in