17mm Hex Hub for 6mm shaft motor.

Wanted to reduce weight from using brass/steel hubs, so printed a beefed up ASA version for 6mm shaft motors on a low speed robotics project.

Printed in ABS/ASA at 100% fill to maximise strength.

Holes for M3 grub screws and M4 wheel bolt will require tapping or a little force to get screws to tap themselves.

6mm Shaft and 17mm hex end should be a tight fit. If to tight maybe under size by a small margin, or reduce over extrusion to get a good fit.

If you like or use this please send