Thingiverse
24mm Rumble Motor Mount
par CaseThings
0
Téléchargements
1
Likes
0
Makes
V2:
Added relief to mounting tab to allow easier flex of the clamping.
Main diameter opened to 24.5mm to accept 24.4mm motor body as intended.
Original Description:
All holes sized for 5mm hardware.
Split into left/right pieces to allow for flexibility when mounting to either gas/brake width.
Opening is 24mm to allow clamping onto 23.5mm DIA motor.
Mounting tab holes are 18mm on center - should accommodate most of the hole positions higher up the vertical braces.
Added relief to mounting tab to allow easier flex of the clamping.
Main diameter opened to 24.5mm to accept 24.4mm motor body as intended.
Original Description:
All holes sized for 5mm hardware.
Split into left/right pieces to allow for flexibility when mounting to either gas/brake width.
Opening is 24mm to allow clamping onto 23.5mm DIA motor.
Mounting tab holes are 18mm on center - should accommodate most of the hole positions higher up the vertical braces.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !