Thingiverse
25 cubic millimeter powder scope
by wsamerino
8
Downloads
6
Likes
0
Makes
Design to be used with my powder supplements which required 14 grams for each servings. Hence I try to design a scoop that able to get correct dosage every scoop.
Info:
Volume: 25 cm3 or 25 ml
Printing:
- make sure you can print overhangs (small surface area)
Improvements:
- you may coat the internal with a layer of AB epoxy resin. (you are doing it at your own risk)
- Require at least 30 days to cure, is chemically inert, suitable to scoop powder ONLY.
- This is to avoid moisture and prevent powder from stuck between the printed layer.
Info:
Volume: 25 cm3 or 25 ml
Printing:
- make sure you can print overhangs (small surface area)
Improvements:
- you may coat the internal with a layer of AB epoxy resin. (you are doing it at your own risk)
- Require at least 30 days to cure, is chemically inert, suitable to scoop powder ONLY.
- This is to avoid moisture and prevent powder from stuck between the printed layer.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
