250 Quade Racer

Tested 8/25: Flies like a Scalding Ape!! Have not mounted the Fatshark or Gopro Session to it yet, but I am confident that it will still perform and have plenty of power. Parts used below:

Turnigy 3cell 2200mah
Emax 15amp ESC
ARRIS 1806 2300kv Brushless motors
KK2 Flight Controller (also set up to run DJI Naza light)
Spectrum 6ch Receiver
5045 Genfan props

COMPLETED 8/18/16 : Finished Printing complete. Adding Hardware and Electronics. . Added landing gear. Landing gear optional or you can use four points when installing the upper slab and utilize 3" bolts as shown.

Quade Arms: .2 Resolution ,75% Lateral Infill ,w/Supports, No Raft
Lower Slab: .2 Resolution, 40% Infill, No Supports, No Raft
Upper Slab: .2 Resolution, 40% Infill, No Supports, No Raft
Landing Gear: .2 Resolution 100% Infill w/Raft and Supports
Both Canopies: .2 Resolution, 10% Infill, W/Raft and Supports

UPDATE 8/15 Printed well had to make some changes to the motor mounts. Updated original design.