250G Spool Holder Generic - Any Printer

This is the simplest spool adaptor you are likely to find. I added a side spool adaptor to my P1S, but it doesn't take 250G spools. So, I created this simply small spool holder that is stuck on the side of the printer using two-sided tape. You can use any 2-sided tape, but I prefer the stuff linked below because while it sticks very well, it is easy to remove or reuse. This can be used on any printer and on any side that is appropriate. If there is a place to stick it, it will work. There are two parts to this print. You only need the second part (disk) if you feel your small spool might walk off the shaft, which didn't happen to me. If you use the second part, drill a hole through the disk slightly larger than the diameter of the screw, and then drill a hole half that diameter in the side of the spindle. Try and drill the small hole through both parts first and offset towards the top. That way you can turn the disk toward the top and it will stop the spool from jumping off. Ju