Hypercube Prusa i3 MK2 Direct Drive Extruder

Print this in ABS because it is so close to the hotend. PLA will be to weak - PETG might work but is not tested!

Everything you need except the pulley should be left over from the hypercube build. You will need: (if I counted everything right)

9x M3 nuts
6x M3 x 10 screws
4x M3 x 35 screws
4x M3 x 30 screws
1x M3 x 20 screw
4x M4 nuts (used to hold springs in place)
2x springs (you can take them from ballpoint pen)
1x M8 pulley (Mk8 Gearbest (affiliate):
https://www.gearbest.com/3d