Thingiverse
Anet A8 Z motor cover
by Wayner1973
16
Downloads
8
Likes
0
Makes
After testting the heat produced by the Z motor even under long prints they just don't get hot.
My printer is in a small alcove and fits by about 5mm so its almost impossible to mount a power switch with easy acess near the PSu for power and lights Etc.
These pair of left and right handed covers have enough angle on them to allow a switch or switches to be installed i have uploaed 2 blanks ( left and right) plus a 3rd with a 16mm circle hole which is where im putting my first swtich as and
My printer is in a small alcove and fits by about 5mm so its almost impossible to mount a power switch with easy acess near the PSu for power and lights Etc.
These pair of left and right handed covers have enough angle on them to allow a switch or switches to be installed i have uploaed 2 blanks ( left and right) plus a 3rd with a 16mm circle hole which is where im putting my first swtich as and
Sign in to leave a comment
Sign in