Anet A8 Dual Bowden Conversion

Really liked this design, however I wanted to keep my X-Axis chain and needed a mount for the Tronxy sensor.

I pulled the blower fan mount a tad further away from the X-Carriage mount as I felt it was a bit too tight. I made an attempt at partitioning the fan output so that there was equal flow to each hot end, though it's not as equal as I'd like still - thus I used tape for now.

Also opted to use https://www.thingiverse.com/thing:2356276 by TGYK for the hot end fan.

Printed in AB