Thingiverse
HyperCube (2020 Extrusion) Anti-Vibration Foot
by superjamie
68
Downloads
26
Likes
0
Makes
Feet intended to go on the HyperCube or any other 2020 extrusion.
You'll need to tap the bottom of your extrusion to add these, I have included models for both M5 and M6 thread.
If you don't want to tap your extrusion, you could use my [HyperCube Leg Extension](https://www.thingiverse.com/thing:2379397) as pictured in black.
Use an adhesive felt floor protector (also pictured) once you have them fastened down, the ones I have are 25mm in diameter.
OpenSCAD source is included if you w
You'll need to tap the bottom of your extrusion to add these, I have included models for both M5 and M6 thread.
If you don't want to tap your extrusion, you could use my [HyperCube Leg Extension](https://www.thingiverse.com/thing:2379397) as pictured in black.
Use an adhesive felt floor protector (also pictured) once you have them fastened down, the ones I have are 25mm in diameter.
OpenSCAD source is included if you w
Sign in to leave a comment
Sign in