Thingiverse
Small Tower Tester
by tsh2
6
Downloads
4
Likes
0
Makes
Quicker to print and half the filament of a benchy, this was a quick idea to make a test part which can be printed to sweep filament parameters (particularly temperature).
It contains a nearly flat base, a 45 degree overhang, some small detail and some (small) flat sides. The idea was not to make something easy to print, but something that might show up some differences in print quality more easily.
Prints in about 30 minutes, 1.2m/3g filament. Small enough to fut under the X bearings on a
It contains a nearly flat base, a 45 degree overhang, some small detail and some (small) flat sides. The idea was not to make something easy to print, but something that might show up some differences in print quality more easily.
Prints in about 30 minutes, 1.2m/3g filament. Small enough to fut under the X bearings on a
Sign in to leave a comment
Sign in