Thingiverse
20mm calibration cube with hole 10mm
by annu333
37
Downloads
13
Likes
1
Makes
Because I'm using Cura then I have only Cura settings here.
This is to calibrate your printer outside walls and also inside walls. If the inside hole is not 10mm then you have to change the setting in Cura:
Print setup - Custom - Shell - Horizontal Expansion
Calculation:
(Measured value - 10mm)/2=setting in Cura
Exam. (9.28-10)/2=-0,36
This is to calibrate your printer outside walls and also inside walls. If the inside hole is not 10mm then you have to change the setting in Cura:
Print setup - Custom - Shell - Horizontal Expansion
Calculation:
(Measured value - 10mm)/2=setting in Cura
Exam. (9.28-10)/2=-0,36
Sign in to leave a comment
Sign in