Thingiverse
Aurora 100 Swift camera guard
by Patchlead
1
Downloads
3
Likes
0
Makes
Print at 0.2 layers and no supports.
The problem is with this one it needs to sit on the ring side down. I need to rotate it 58.2 degrees.
Recomend ABS
For the camera to fit, you need to file the front standoffs. File the tubes in half, leaving about 5mm untouched on the top and bottom for the screws. Then cut the top plate CF back so there is enough fro the front stands only.
add thin heat-shrink to the verticals then to protect the runcam Swift sparrow.
Hot glue the camera in pl
The problem is with this one it needs to sit on the ring side down. I need to rotate it 58.2 degrees.
Recomend ABS
For the camera to fit, you need to file the front standoffs. File the tubes in half, leaving about 5mm untouched on the top and bottom for the screws. Then cut the top plate CF back so there is enough fro the front stands only.
add thin heat-shrink to the verticals then to protect the runcam Swift sparrow.
Hot glue the camera in pl
Sign in to leave a comment
Sign in