Thingiverse
Mode 2 Ghost Parametric Arm Guard TPU/TPE
30
Downloads
17
Likes
0
Makes
Arm guard for the awesome new Mode 2 Ghost ultralight 5' prop racing frame.
This will:
- Prevent your motor wires from being cut
- Hold down wires/esc on your arm
- not slip when printed in TPU/TPE
- require 4 cable ties
- Look clean and smooth
- hold your antennas like a boss
- print in plastic (tolerances built in)
- is parametric (adjust to any frame/esc/thickness/length desired)
Slots for 2.5mm cable ties, print right side up, so that the two sides bridge at top.
Adj
This will:
- Prevent your motor wires from being cut
- Hold down wires/esc on your arm
- not slip when printed in TPU/TPE
- require 4 cable ties
- Look clean and smooth
- hold your antennas like a boss
- print in plastic (tolerances built in)
- is parametric (adjust to any frame/esc/thickness/length desired)
Slots for 2.5mm cable ties, print right side up, so that the two sides bridge at top.
Adj
Sign in to leave a comment
Sign in