Folding Propeller 9x6 for RC plane

Tested this prop on the plane, at 10k rpm , zero vibrations, no breaks or cracks. (PLA material)

Im fairly impressed with the results, the hole for motor shaft is 6 mm, feel free to adjust the dimensions.

You will need 2 M3*20 mm bolt and nut to assemble the entire prop .

I suggest to print this at low/medium speed, with (!) 100% infill. With a 0.4 mm nozzle I use 0.3 mm of layer height. I also recommend to use heatbed and brim 3mm.

DISCLAIMER: Im not responsable of any injury, da