Thingiverse
UP3D Plus 2 Plexi Enclosure
by JamesNewton
1
Downloads
1
Likes
0
Makes
Manually edited the SVG files from fumalcon to
1. Break each part out into a separate file.
2. change units to mm and
3. changed line width to 1mm so it is visible (Epilog users will need to go back to 0.001, I guess?)
4. scale to correct size. (I hope)
The scale is the scariest part as it was based on measuring my actual printer and then measuring the SVG file and then scaling everything by that factor. It ended up being scale(1.339) as a best guess, and I DID cut one side panel in car
1. Break each part out into a separate file.
2. change units to mm and
3. changed line width to 1mm so it is visible (Epilog users will need to go back to 0.001, I guess?)
4. scale to correct size. (I hope)
The scale is the scariest part as it was based on measuring my actual printer and then measuring the SVG file and then scaling everything by that factor. It ended up being scale(1.339) as a best guess, and I DID cut one side panel in car
Sign in to leave a comment
Sign in