Thingiverse

SIMPLE SPOOL ADAPTER

by Howardson

10 Downloads

9 Likes

0 Makes

Download Model

3DSOLUTECH Anet A8 filament spool holder spool spool holder

After browsing I couldn't find a spool adapter I liked so I designed this one. It's very simple and need NO extra bits i.e. bearings, washers, or nuts.
The OD is 56.5mm or 2.22in (highest measurement I could get after printing was 56.9.)
the length it 75mm or 2.95in.
I recommend printing with the flange touching the bed. Turn OFF supports because you can not get inside to remove them easily. I added a large fillet to the inside to help print the top with little to no stringing.
Fits my Solut

Source

Thingiverse

Comments