Thingiverse
Replicator 2/2x Pivoted Blower Duct
by insane78
27
Downloads
15
Likes
0
Makes
I decided to modify original blower duct of whpthomas in order to gain access to the screws under the extruder carriage.
This version has a pivot between the support and the duct, so you will get off the carriage without unscrewing the duct, but simply moving it.
As pin i used a 3x20 screw because only the last piece of duct is threaded, the remaining is a bit larger to avoid the pin unscrews by rotation.
Printed using PLA at 210°C, layer 0.2, raft and supports (simplify3d)
Infill 20%
2
This version has a pivot between the support and the duct, so you will get off the carriage without unscrewing the duct, but simply moving it.
As pin i used a 3x20 screw because only the last piece of duct is threaded, the remaining is a bit larger to avoid the pin unscrews by rotation.
Printed using PLA at 210°C, layer 0.2, raft and supports (simplify3d)
Infill 20%
2
Sign in to leave a comment
Sign in