Thingiverse
Taz 6 print cooling fan ducts
by AKADAP
7
Downloads
1
Likes
0
Makes
This is a pair of fan ducts for the Taz 6.
I was experimenting with bridging, and it looked to me like the stock fan ducts were aimed well below the tip of the nozzle. I also did not like how you were required to remove the fan before you could remove the fan duct when working on the printer, also the stock fan duct blocks about 25% of the fan.
I'm not sure these new fan ducts help bridging much, I concluded that my two slicers are not very good at handling bridging. Slic3r sometimes fails to
I was experimenting with bridging, and it looked to me like the stock fan ducts were aimed well below the tip of the nozzle. I also did not like how you were required to remove the fan before you could remove the fan duct when working on the printer, also the stock fan duct blocks about 25% of the fan.
I'm not sure these new fan ducts help bridging much, I concluded that my two slicers are not very good at handling bridging. Slic3r sometimes fails to
Sign in to leave a comment
Sign in