Thingiverse

Prusa Filament Out Sensor

by jmillerfo

71 Downloads

47 Likes

0 Makes

Download Model

Filament Sensor Octoprint filament prusa i3 mk2s

12/30/17 Update
This part supports Filament Out sensing directly by the Prusa Mini-Rambo 1.3a board. See section below for implementation. __Please note this requires a non-standard firmware load.__ This far I have not found any item supported by Prusa 3.1.0 firmware that this modified firmware does not support as well. This has the advantage of supporting Filament Out sensing when printing from the SD card as well as OctoPrint.

This **Prusa i3 MK2(S)** *Filament Run Out Sensor* detects

Source

Thingiverse

Comments