2S Lipo Battery Holder - 16mm x 16mm - RakonHeli 66mm Brushless Whoop

I tore through the original RakonHeli 2S battery holder within a couple dozen batteries, so I decided to model my own. The battery slots were sized to slip-fit the 260HV batteries. The fitting isn't super tight, but the batteries still stay within the holder.

A few tips...
-The model can be orientated as-is or rotated 180 degrees. Depending on the orientation, you may have to add additional supports.
-Make sure that you print with the layer height between .1-.15mm. Smaller the better.