Thingiverse
CR-10 X carriage
by yxope
88
Downloads
39
Likes
0
Makes
This is an x-carriage for the CR-10. It is made for 2pcs 50x15 blower fans. It also uses a 30mm fan for the hotend cooling.
All screws is M3. I use M3 loc nut behind the hotend.
So far it is working fine, and the cooling is really good.
The fan ducts is printed on its side flat on the buildplate with 15% grid support. I find the support easy to remove with Cura default settings for support.
The hotend cooler is printed on its "belly" with 15% Lines Support.
I have printed everything
All screws is M3. I use M3 loc nut behind the hotend.
So far it is working fine, and the cooling is really good.
The fan ducts is printed on its side flat on the buildplate with 15% grid support. I find the support easy to remove with Cura default settings for support.
The hotend cooler is printed on its "belly" with 15% Lines Support.
I have printed everything
Sign in to leave a comment
Sign in